Highlights:

• PoE injector according to IEEE802.3af/at with max. power of 30W
• 2x RJ45 Gigabit ports
• PoE output 55VDC@30W Midspan PoE PIN´s 4/5 (+) and 7/8(-)
• internal power supply
• compact design
• Includes 1.5m power cable with IEC-C5 to IEC-CEE7 protective contact cable
• NEW: Wall mountable

Intelligent power supply via network without a switch

With the ALLNET ALL0488V6 Power over Ethernet injector you can install your PoE-capable IP devices such as WLAN access points, VoIP telephones and much more completely independently of existing power sockets.

For example, the most ideal installation locations in a building can be selected for WLAN access points without having to pay attention to the power cabling.

Switches that are not PoE-capable can be "retrofitted" with Power over Ethernet at low cost, especially if you only need a few ports with PoE supply. Here the ALL0488V6 saves you having to purchase a PoE switch.

The ALLNET ALL0488V6 supports the IEEE802.3af & IEEE802.3at standard with a maximum power of 30W watts.

The ALL0488V6 does not need to be configured. It has an RJ45 input socket and an RJ-45 output socket through which the switch and end device are connected to the PoE injector. As is usual in Ethernet, the cable length can be up to 100 meters in total between the switch and the end device.

Thanks to its compact design, the ALLNET ALL0488V6 can be installed very inconspicuously. It has an internal power supply and supplies the PoE voltage on pins 4.5 (+) and 7.8 (-).